Intel Integrated Touchscreen Computer J2 650 Manuel d'utilisateur télécharger pdf (Page 72)

650 System Manual (Draft)

Version 0.4 August 20, 2008

650 UPS

Specifications

Hardware

To install and use the J2 UPS module:

1: Remove the power supply adapter form the base of the unit.

2: Install the UPS module where the power supply was mounted.

3: Connect the power output jack of the UPS to the power in jack of the unit.

4: Connect the Serial cable of the UPS to the serial port you wish to use. *

5: Connect the power supply adapter to the UPS power in jack.

6: Connect the power supply adapter to the mains power. **

7: Configure the Windows UPS drive as shown.

Picture to be added here

* The serial port connection is not needed for Windows CE.

** The mains power should be applied for 3 hours to fully charge the batteries. The unit

may be running during this time but will take longer to charge.

Batteries Run Time 2 Hours for the standard 650. Run time will vary

depending on the processor used and application load

Power In 19 Volts DC

Power Out 13-16.8 Volts DC, 7.2 amps maximum

Data Interface RS232 DB9 connector

Batteries Type 2 – 4 18650 cell Li-Ion pack with protection circuit

Battery Life 300 full discharge cycles

Charge Time 3 hours

Charger Type Smart Microcontroller based

Software XP Standard Generic UPS driver / J2 Smart UPS driver

Size 6” x 3.1” x 1.7” (152mm x 79mm x 43mm)

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 78

Pas de commentaire

Intel Integrated Touchscreen Computer J2 650 Manuel d'utilisateur Page 72