Intel ISP1100 Manuel d'utilisateur télécharger pdf (Page 41)

Removing/Installing Server Components 41

Removing the Riser and Add-in Card(s)

Perform this procedure to remove the riser and add-in card(s) from the server board. Refer to

Figure 21 while performing this procedure.

CAUTION

Do not attempt to remove an add-in card without first removing the riser card

from the server board. If you do, you can damage the board(s) or connectors

due to clearance limitations. If there are any add-in cards already installed,

remove the riser and the attached add-in card(s) together as described in the

following procedure.

1. Grasp the riser card, with add-in card(s) attached, at each end (A) and gently rock and lift until

the riser releases from the server board connector (B).

2. Remove the riser and add-in cards from the server board.

OMO9459

Figure 21. Removing the Riser and Add-in Card(s)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 80 81

Pas de commentaire

Intel ISP1100 Manuel d'utilisateur Page 41