Intel ISP1100 Manuel d'utilisateur télécharger pdf (Page 39)

Removing/Installing Server Components 39

Installing the 3.5-inch Diskette Drive in the Drive Bay

Perform this procedure to install the mounting bracket and drive in the server drive bay. Refer to

Figure 19 while performing this procedure.

1. Connect the power and data cables (C) to the drive. The red stripe (D) on the data cable

faces toward the center of the drive.

2. Place the mounting bracket and drive in the server chassis and align the three screw holes (A)

in the mounting bracket (two on one side and one on the other) with the mating holes in the

server chassis.

3. Use a Phillips screwdriver and the three screws (B) removed from the mounting bracket in the

preceding “Removing the 3.5-inch Diskette Drive” procedure to securely attach the mounting

bracket and drive to the server chassis.

OMO9457

Figure 19. Installing the 3.5-inch Diskette Drive in the Drive Bay

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 80 81

Pas de commentaire

Intel ISP1100 Manuel d'utilisateur Page 39