Intel Server SE7230NH1-E Manuel d'utilisateur télécharger pdf (Page 8)

Safety Information

viii Intel

Server Board SE7230NH1-E and Intel

Server Platform SR1475NH1-E User’s Guide

Warnings

Heed safety instructions: Before working with your server product, whether you are

using this guide or any other resource as a reference, pay close attention to the safety

instructions. You must adhere to the assembly instructions in this guide to ensure and

maintain compliance with existing product certifications and approvals. Use only the

described, regulated components specified in this guide. Use of other products /

components will void the UL listing and other regulatory approvals of the product and

will most likely result in noncompliance with product regulations in the region(s) in which

the product is sold.

System power on/off: The power button DOES NOT turn off the system AC power. To

remove power from system, you must unplug the AC power cord from the wall outlet.

Make sure the AC power cord is unplugged before you open the chassis, add, or remove

any components.

Hazardous conditions, devices and cables: Hazardous electrical conditions may be

present on power, telephone, and communication cables. Turn off the server and

disconnect the power cord, telecommunications systems, networks, and modems attached

to the server before opening it. Otherwise, personal injury or equipment damage can

result.

Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives,

boards, and other parts. We recommend that you perform all procedures in this chapter

only at an ESD workstation. If one is not available, provide some ESD protection by

wearing an antistatic wrist strap attached to chassis ground any unpainted metal surface on

your server when handling parts.

ESD and handling boards: Always handle boards carefully. They can be extremely

sensitive to ESD. Hold boards only by their edges. After removing a board from its

protective wrapper or from the server, place the board component side up on a grounded,

static free surface. Use a conductive foam pad if available but not the board wrapper. Do

not slide board over any surface.

Installing or removing jumpers: A jumper is a small plastic encased conductor that slips

over two jumper pins. Some jumpers have a small tab on top that you can grip with your

fingertips or with a pair of fine needle nosed pliers. If your jumpers do not have such a

tab, take care when using needle nosed pliers to remove or install a jumper; grip the

narrow sides of the jumper with the pliers, never the wide sides. Gripping the wide sides

can damage the contacts inside the jumper, causing intermittent problems with the

function controlled by that jumper. Take care to grip with, but not squeeze, the pliers or

other tool you use to remove a jumper, or you may bend or break the pins on the board.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 89 90

Pas de commentaire

Intel Server SE7230NH1-E Manuel d'utilisateur Page 8