Intel SHG2 Manuel d'utilisateur télécharger pdf (Page 29)

Server Board installation 29

Installing the Processor(s)

CAUTIONS

If only one processor is to be used, it must be installed in the Processor

Socket labeled CPU1, which is the socket closest to the corner of the

server board.

If you are adding a second processor to your system, you must verify that the

second processor is identical in speed to the first processor.

This server board has “zero-insertion-force” sockets. If processor does not

drop easily into socket holes, make sure the lever is in the full-upright

position and the processor is oriented properly.

1. Observe the safety and ESD precautions at the beginning of this chapter and the additional

precautions given here.

2. Install the retention brackets for the primary processor by inserting the retention brackets and

tightening the four retention screws. The primary processor socket is located nearest to the

corner of the server board. If installing a second processor, install the retention brackets for the

secondary processor.

OM14364

A. Heat Sink Retention Bracket

Figure 10. Installing the Retention Brackets

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 99 100

Pas de commentaire

Intel SHG2 Manuel d'utilisateur Page 29