Intel Edison Compute Module (IoT) Spécifications télécharger pdf (Page 22)

Shield pin configuration

6.3 LEDs

The Intel® Edison kit for Arduino has three LEDs. (See Figure 5 for locations.)

• DS1 is the reset LED. It will turn on when the Intel® Edison processor is running. When the processor is in

reset and asserting RESET_OUT# low, it will turn off.

• DS2 is the standard LED on the Arduino* board. It runs using the ‘blink’ code or whenever Digital I/O 13 is

asserted High. It can be used as an indicator under direct control.

• DS3 is the battery charging LED. It will turn on when the LTC4067 is charging an attached battery.

Intel® Edison Kit for Arduino*

Hardware Guide December 2014

22 Document Number: 331191-004

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Pas de commentaire

Intel Edison Compute Module (IoT) Spécifications Page 22