Intel SR1450 Manuel d'utilisateur télécharger pdf (Page 51)

Hardware Installations and Upgrades

Intel

Server Chassis SR1450 User Guide 51

Replacing the Intel

Local Control Panel

Your server must be operated with a control panel installed. The steps for replacing the Intel Local

Control Panel are listed below.

CAUTION

The control panel is NOT hot swappable. Before removing or replacing the

control panel, you must first take the server out of service, turn off all

peripheral devices connected to the system, turn off the system by

pressing the power button, and unplug the AC power cord(s) from the

system or wall outlet.

1. Observe the safety and ESD precautions at the beginning of this book. See “Safety

Information.”

2. Power down the server and unplug all peripheral devices and the AC power cable(s).

3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”

4. Remove the USB cable from the routing channel.

5. Press the latch at the back of the control panel (See letter “A” in the figure below) and pull the

control panel out several inches.

6. Disconnect the front panel cable and the USB cable from the front panel control board at the

rear of the control panel.

7. Slide the control panel out through the front of the chassis. See letter “B” in the figure.

TP01620

Figure 38. Removing the Intel

Local Control Panel from the Chassis

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 86 87

Pas de commentaire

Intel SR1450 Manuel d'utilisateur Page 51