Intel D101GGC Fiche technique télécharger pdf (Page 19)

Product Description

1.7 Legacy I/O Controller

The SMSC SCH5017 Legacy I/O controller provides the following features:

• One serial port

• One parallel port with Extended Capabilities Port (ECP) and Enhanced Parallel Port

(EPP) support

• Serial IRQ interface compatible with serialized IRQ support for PCI Conventional bus systems

• PS/2-style mouse and keyboard interfaces

• Interface for one 1.44 MB or 2.88 MB diskette drive

• Intelligent power management, including a programmable wake-up event interface

• PCI Conventional bus power management support

The BIOS Setup program provides configuration options for the I/O controller.

1.7.1 Serial Port

The Serial port A connector is located on the back panel. The serial port supports data transfers at

speeds up to 115.2 kbits/sec with BIOS support.

For information about Refer to

The location of the serial port A connector Figure 6, page 37

1.7.2 Parallel Port

The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS Setup

program to set the parallel port mode.

For information about Refer to

The location of the parallel port connector Figure 6, page 37

1.7.3 Diskette Drive Controller

The I/O controller supports one diskette drive. Use the BIOS Setup program to configure the

diskette drive interface.

For information about Refer to

The location of the diskette drive connector Figure 7, page 38

1.7.4 Keyboard and Mouse Interface

PS/2 keyboard and mouse connectors are located on the back panel.



NOTE

The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top PS/2

connector. Power to the computer should be turned off before a keyboard or mouse is connected or

disconnected.

For information about Refer to

The location of the keyboard and mouse connectors Figure 6, page 37

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 73 74

Pas de commentaire

Intel D101GGC Fiche technique Page 19