Intel I/O Processor Manuel d'utilisateur télécharger pdf (Page 8)

Linux - Debian—Host Setup

June 2005 Intel

I/O Processors Linux-Debian Installation Guide

8 Order Number: 306507001US

2.1 Minicom Setup

Follow these steps to configure the minicom terminal emulator:

1. Log in as root

2. Start minicom setup (“minicom -s”)

3. Select [Serial port setup]

a. Change Serial Device to the appropriate com port (/dev/ttyS0 is COM1, /dev/ttyS1 is COM2

etc.)

b. Change Bps/Par/Bits to 115200 8N1, this is the default setting for all the Customer Reference

Board Evaluation Platforms.

c. Change all flow control settings to No/Off

4. Select [Modem and dialing parameter setup]

a. Change Init string to “^M”

b. Change Reset string to “^M”

5. Select [Save setup as dfl] to save setup as default

6. Select [Exit] to exit setup and enter minicom

7. Log out as root

2.2 Host Networking Setup

These instructions assume there are two ethernet controllers and are using a private subnet of

192.168.0.0 for the Intel XScale

microarchitecture-Linux target. Normal disclaimers about

security apply.

Launch the system-config-network utility on the Fedora host system and configure the secondary

ethernet controller with an IP of 192.168.0.1 and a subnet mask of 255.255.255.0.

When providing full internet access to the Intel XScale

microarchitecture-Linux target, it is

possible to configure the IA Linux host to act as a NAT router, connecting the 192.168.0.0 subnet

to the primary network. Instructions to do this vary depending on the distribution. Please consult

the appropriate vendor documentation for this.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Pas de commentaire

Intel I/O Processor Manuel d'utilisateur Page 8